Introduction

u-blox u-center is a GUI application for evaluation, performance analysis and configuration of u-blox GNSS modules. The application can be obtained from the u-blox website at https://www.u-blox.com/en/product/u-center-windows.

Instructions

Enable bridge mode on Zubax GNSS

Connect to the CLI on Zubax GNSS and execute the command gnssbridge. Close the CLI application afterwards.

Launch u-blox u-center

Launch the u-blox u-center application and make sure it is connected to the correct COM port. The baud rate is irrelevant and can be set arbitrarily.

Optional: configure the messaging rates

In the u-center, open the Configuration view, select the section MSG (Messages), select message 01-35 NAV-SAT, and set the rate to 1.